Micro Detuner
Micro Detuner
LIMITED RUN
Think of this as a daily management tool for the crippling lack of swirl in your life. Ask your doctor about MICRO DETUNER.
DETUNER - four pitch shifted voices, from sweet to sour. Stereo panning, adjustable spread, and pitch oscillation allow for incredibly lush soundscapes.
REVERB - medium hall reverb, fed from the detuner. Subtle ambience or big wash, up to you.
Side effects may include sweating, itch eyes, hives, tiredness, ringing in ears, raccoons, check engine light mania, fear of soft drinks. Ask your doctor before starting or stopping MICRO DETUNER.
MORE INFO:
Micro Detuner uses the advanced FXCore DSP chip, which also powers our Leap Series and Venture Series pedals. We’re using it to put two fully-featured effects into a single compact pedal.
Detuner creates four copies of your signal and pitch-shifts each by a tiny amount. These detuned voices combine in stereo to create a shimmering chorus tone that isn’t chorus. The TUNE and MIX controls select how much detuning and dry signal are in the final output. PAN applies a stereo tremolo to spin your signal back and forth between your speakers. WIDE sends two voices each to left and right, or combines them in the center. And OSC applies a pitch modulation to the detuned voices for a deeper swirl.
REVERB is a medium-large Hall reverb and is fed by the Detuner output. This applies a modulation to the reverb even when the Detuner is bypassed. Reverb has a single SIZE control which sets the reverb mix and decay at the same time.
Hold the DETUNER footswitch to ramp the tuning to max or min, depending on how the TUNE control is set.
Created especially for the Midwest Pedal Fest, Detroit 2026.
SPECIFICATIONS:
Input: Mono or stereo (TRS)
Output: Mono or stereo (TRS)
Input Impedance: 1M ohms
Output Impedance: 560 ohms
Power Requirements: DC 9V only, 250mA or greater
Requires isolated DC power supply
Dimensions: 2.4” x 4.7” x 1.6” W x H x D not including knobs (67 x 120 x 42mm)
Low-noise op-amp input stage
Tailored analog section for low noise operation
Top-mounted audio and power jacks
Buffered bypass with soft-touch switching and reverb trails


