* REWIND CHANGES:

     v1.01 3/8/23
     Removed display brightness configuration option
     Added knobs reading mode configuration option
     Added Knob Mode = Pickup, user must turn pot to match display before the pedal will change values
     Added eeprom ready state check
     Fix issue with EEPROM reading on 24CW128-equipped pedals

     v1.00d 2/23/22
     DYNAMIC mode now shows when envelope detector is bypassed
     DYNAMIC mode now has DUCK option, decreases wet level when signal is present
     Fix issue with tap divisions going away during ramps / expression!
     Fix issue with tap tempo changing expression settings for the worse
     
     v1.00c
     Ramp always resets after program load, ramp also clears if trigger mode is changed
     Increased reverse bit crush bypass level, should bypass at lowest knob settings
     Fix DUAL mode bar for time2 not being drawn correctly
     
     v1.00b
     Added ms / bpm time display to delay 2 of DUAL mode
     added dual bank (1-16 or 17-32)
     now sows RAMP bar even if EXT CLOCK is present
     Change low-cut values for TAPE mode, set AGE to minimum for max low end

     v1.00a
     Added time display options
     removed time display from tap bar display config

     v1.00 Initial Release
     Tweaked balance control for wet / dry, improve steep end drop
     Added sysex command for reset presets
     Cleaned up sysex commands for preset upload / download